Seton Hill SAT Scores, GPA, and ACT (2026)

Seton Hill SAT scores land in a middle 50 range of 1020 to 1240. That band is what the seton hill sat scores question really comes down to: score inside it and you read like a typical admitted student at this Greensburg, Pennsylvania campus. The average sits at 1117, closer to the lower half of that spread, so you do not need a top result to be in the mix. Half of enrolled students scored between the 1020 floor and the 1240 ceiling. The other half landed above or below those marks.

The acceptance rate here is 79.5%, so close to 4 out of 5 applicants get in. That takes pressure off any single number. Seton Hill is a private nonprofit university with about 1,492 students, a small setting where an admissions reader can look at your whole file instead of sorting it by a hard cutoff. Testing was optional in the most recent federal data, which means you can send scores when they help your case and leave them off when they do not. If your result sits inside or above the 1020 to 1240 band, sending it usually works in your favor. The ACT range for the same class ran 19 to 27, so either test can carry the score part of your application.

Here is how to read your score against Seton Hill's numbers. A total below 1020 puts you under the 25th percentile, which does not close the door at a school admitting near 79.5% of applicants, but it does put more weight on your grades, courses, and the rest of the file. A score between 1020 and 1240 sits inside the middle 50, right where most enrolled students land, and anything above 1240 places you in the top 1 out of 4 for this class.

The section splits are even at Seton Hill. Reading and Writing runs 510 to 620, and Math runs the same 510 to 620. Neither section sets a higher bar than the other, so you can build your total from whichever side is your strength without a penalty. If one section is dragging your total under 1020, lifting it back toward 620 is usually the quickest path to landing inside the middle 50 range rather than under it.

Admitted students at Seton Hill typically present an unweighted GPA in the range of 3.0 to 3.5. That is a workable target for most applicants, and it fits a school that admits close to 79.5% of the people who apply. A GPA in that band, paired with a solid transcript, keeps you in normal range for this campus.

The grade itself is only part of the read. Grades earned in rigorous courses count as much as the number on the page, so a 3.3 built on harder classes can look stronger than a higher average from an easier load. If your GPA sits at the lower edge of the 3.0 to 3.5 band, a strong SAT is the fastest way to offset it. A score at or above the 1117 average, and better yet up near the 1240 mark, gives an admissions reader a clear reason to look past a softer transcript and read the rest of your file with more confidence.

Set your targets against the actual percentiles. A total at or above 1020, the 25th percentile, keeps you inside the range Seton Hill admits from. A total at or above 1240, the 75th percentile, puts you in the top quarter of the class and makes your score a clear asset rather than a neutral one. A practical aim for most applicants is the 1117 average as a floor and 1240 as a stretch.

Because each section carries an even 510 to 620 span, split your prep by where the points are easiest to add first. Our score plans map a week by week path from your current total to the number you want. If you are not sure where you stand today, start with a diagnostic to pin down your Reading and Writing and Math baselines. From there, pick the single section that gets you over 1020 fastest and drill it this week.